Mojave Audio MA-301 FET Condenser Microphone
Large diaphragm multi-pattern condenser microphone
The MA-301fet is a multi-pattern large diaphragm, solid-state condenser microphone. Based upon the popular MA-201fet designed by David Royer, the MA-301fet adds a 3-posistion pickup pattern selector, a15dB pad and a switchable bass roll-off.
In stock
Part No:
MOJAVE-301FET
£789.00
£657.50
Did you find this item priced lower than
£789.00
somewhere else?
Yes
The MA-301fet is a multi-pattern large diaphragm, solid-state condenser microphone. Based upon the popular MA-201fet designed by David Royer, the MA-301fet adds a 3-posistion pickup pattern selector, a15dB pad and a switchable bass roll-off.
Utilizing a 3-micron gold-sputtered capsule, high-quality Jensen audio transformer, military-grade FET and custom designed low-noise resistors, the MA-301fet performs at a level reminiscent of some of the best loved classic condenser microphones. Each MA-301fet microphone is carefully tested and evaluated, then packaged in its protective case with a professional grade shockmount.
- Multi-pattern: Cardioid, Omnidiectional, Figure-eight (Bi-directional)
- Switchable 15dB pad
- Switchable Bass Roll-off
- Hand-selected 3-micron 1" capsule
- Jensen audio transformer
- Military-grade FET
- Custom designed low-noise resistors
- Ultra clean signal path
Recommended Applications
- Vocals
- Voice Over and Broadcast
- High SPL sources, such as Kick Drums and Bass Guitar Amps
- Electric Guitar
- Piano
- Drum Overheads, Drum Rooms
| Specification | Transducer Type: Externally polarized, pressure gradient capacitor - double diaphragm Diaphragm: 1-inch diameter, gold sputtered Diaphragm Thickness: 3 microns Polar Pattern: 3 patterns; omni, cardioid and figure-8 Frequency Response: 20 Hz to 20 KHZ, +/-3 dB at "flat" setting of bass cut switch. Bass cut switch provides 6 dB per octave attenuation below 100 Hertz in "cut" setting Sensitivity: -40.5 dB, re. 1V/pa Maximum SPL: 120 dB with pad off, 135 dB with pad on. Distortion: < 1% @ 120 dB SPL , < 3% @ 134 dB SPL with pad off < 1% @ 134 dB SPL, < 3% @ 148 dB SPL with pad on Self Noise: 14dB nominal, not to exceed 16dB (A weighted) Pad: 15 dB Bass Cut: 6 dB per octave below 100 hertz. Impedance: 550 ohms, transformer balanced (Jensen) Powering: 48VDC phantom power; current 1.2 mA Dimensions and Weight
|
|---|
