This site uses cookies to provide you with the great user experience. Find out more here. By using this site you consent to use our cookies.
Wohler OPT-DANTE (iAM Series)
Enables Decoding and Monitoring of Danteª or AES67 Input Streams
Enable monitoring from up to a 64ch Dante input. Hardware card with software activation key.
Enables decoding and monitoring of Dante input streams in iAM Series products.
Installing a Wohler unit with the Dante hardware option into an existing and functioning Dante network is virtually plug and play. The iAM Series rear panel AoIP jack supports 1Gb/s and 100Mb/s Ethernet devices in Dante Audio over IP network configurations. Channel source selections are made by choosing Input Type ‘AoIP’ in the Configuration-Configure Presets page regardless of which AoIP option is installed. The iAM-series unit is set up at the Wohler factory to be used as a slave rather than a master within the Dante network. Other devices or software, such as a Dante Controller, are expected to be responsible for most device configurations and all audio routing.
More information can be found in the manuals for the products listed below.
The daughter card can be installed in the iAM Series products listed below:
- IAM-MIX8
- IAM-MIX16
- IAM-AUDIO-1
- IAM-AUDIO-2
- IAM-VIDEO-2
Specification | Signal I/O
Features
Interfacing
Physical
|
---|