Sonifex RB-VHCMD16 3G/HD/SD-SDI Embedder & De-Embedder 16 Channel Digital I/O

3G/HD/SD-SDI Embedder & De-Embedder 16 Channel Digital I/O

The RB-VHCMD16 is a 16-channel de-embedder and 16 channel embedder combined into a single 19-inch rack unit. The unit can selectively de-embed any channel within any audio group of an SDI video signal, to any of the digital outputs. After which, the video becomes two independent paths where the audio groups can be selectively deleted or passed through. The unit then embeds any of the digital input channels to available groups within each of the two video paths, which are then sent to the re-clocked SDI outputs.

Part No:
RB-VHCMD16
Usually Ships in 2-3 Days
£2,298.00 £1,915.00
Did you find this item priced lower than £1,915.00 somewhere else? Yes

The RB-VHCMD16 is a 16-channel de-embedder and 16 channel embedder combined into a single 19-inch rack unit. The unit can selectively de-embed any channel within any audio group of an SDI video signal, to any of the digital outputs. After which, the video becomes two independent paths where the audio groups can be selectively deleted or passed through. The unit then embeds any of the digital input channels to available groups within each of the two video paths, which are then sent to the re-clocked SDI outputs.

The de-embedding and embedding channel routing is controlled via the front panel buttons and indicators. There is also LED indication for SDI input status and audio group presence.

The unit can be remote controlled via Ethernet or serial port connections using the Sonifex SCi software.

It has a triple rate SDI receiver with automatic input rate detection and equalisation along with two re-clocked and individually buffered SDI outputs. It supports the full range of single link 3G, HD and SD standards from NTSC and PAL up to 1080p 60Hz.
Each digital input is normally sample rate converted to 48kHz before embedding, so that it is synchronous to the video input, though sample rate conversion can be bypassed on a per input basis allowing SMPTE-337M data to be embedded. All digital outputs are output at 48kHz, synchronous to the video input. There is independent level control for each digital input and output channel, which can be adjusted from -24dB to +24dB in 0.5dB steps.

The digital audio I/O connections are transformer-coupled balanced line interfaces and can be configured to be either 75ohm (AES 3ID) or 110Ω (AES 3) impedance through either a BNC or D-type connector. These connections are paralleled, allowing one type to be used per input or output.

More Information
Specification

Front Panel Controls & Indicators

  • Embed Bank Select: Bank 1 or 2
  • Bank Channel Select: Channels 1, 2, 3 or 4
  • Group Select: Groups 1, 2, 3 or 4
  • Group Channel Select: Group channels 1,2,3 or 4
  • Status: 1 x SDI input status LED / 2 x SDI output LEDs / 4 x Audio group status LEDs

Audio Specifications

  • Maximum Input Level: +27dBu (balanced)
  • Input Impedance: >10kΩ bridging (balanced)
  • Input Levels: +12dBu, +18dBu or +24dBu for FSD (jumper selectable)
  • Signal to Noise: Better than -113dBFS (RMS A-weighted at 24-bit, balanced)
  • Distortion and Noise: Better than -100dB THD+N at 1kHz (balanced)
  • Embed Delay: SD: 600 us / 3G/HD: 300 us

Connections

  • Digital Audio Outputs: 16 outputs via 8 BNCs (S/PDIF) or D-type (AES/EBU)
  • Digital Audio Inputs: 16 inputs via 8 BNCs (S/PDIF) or D-type (AES/EBU)
  • Digital Audio Connectors: 16 x BNC 2 x 25-way D-type socket
  • Power Supply: Universal filtered IEC, continuously rated 85-264VAC @47-63Hz, fused, max 13W

Equipment Type

  • RB-VHCMD16 3G/HD/SD-SDI embedder & de- embedder 16 channel digital I/O

Common Specifications For RB-VHEMA8, RB-VHDMA8, RB-VHCMA4 & RB-VHCMD16

SDI Specification

  • SDI Input: 1 x BNC, 3G/HD/SD-SDI
  • SDI Outputs: 2 x BNC, 3G/HD/SD-SDI, Re-clocked
  • Impedance: 75Ω
  • Output Alignment Jitter: <0.2UI (3G <0.3UI)
  • Output Level: 800mV +/- 10%
  • Return Loss: <15dB at 1500MHz
  • SDI Supported Standards: 270Mbps, SMPTE-259M-C (SD) 1.485 or 1.4835Gbps, SMPTE-292M (HD), 2.97 or 2.967Gbps, SMPTE-424M (3G), SMPTE 425M-A
  • Supported Video Formats: 525/59.94 (SMPTE-125M 625/50 (ITU-R BT.656) 720p/23.98, 24, 25, 29.97, 30, 50, 59.94, 60 (SMPTE-296M) 1035i/59.94, 60 (SMPTE-260M) 1080i/50, 59.94, 60 (SMPTE-274M) 1080p/23.98, 24, 25, 50, 59.94, 60 (SMPTE-274M) 1080pSF/23.98, 24, 25, 29.97, 30 (RP-211) 1080i/50 (SMPTE-295M)1080p/50 (SMPTE-295M)
  • Video Delay: SD: 290 pixels / 22 us
  • HD: 570 pixels / 8 us
  • 3G: 570 pixels / 4 us
  • Embedded Audio: 48kHz, synchronous / SMPTE-272M-ABC / SMPTE-299M
  • Serial Port: RS232, 9 way D-type
  • Ethernet Port: 10/100Mbps
  • Fuse Rating: Anti-surge fuse 2A 20 x 5mm

Physical Specification

  • Dimensions (Raw): 48cm (W) x 15.8cm (D*) x 4.2cm (H) (1U)
    19” (W) x 6.2” (D*) x 1.7” (H) (1U)
  • Dimensions (Boxed): 59cm (W) x 27.5cm (D) x 11cm (H)
    23.2” (W) x 10.8” (D) x 4.3” (H)
  • Weight: Nett: 1.8kg Gross: 2.3kg / Nett: 4.0lb Gross: 5.1lb